Operator's Manual

Figure 18

1. Height of cut lever 2. Clevis Pin

2. T o adjust, remo v e the clevis pin from the

height-of-cut brac k et ( Figure 18 ).

3. Select a hole in the height-of-cut brac k et

cor responding to the height-of-cut desired

and, inser t the clevis pin ( Figure 18 ).

4. Mo v e the lev er to the selected height.

Adjusting the Anti-Scalp

Rollers

W henev er y ou c hang e the height-of-cut, it is

recommended to adjust the height of the anti-scalp

rollers .

Adjusting the Outer Roller

1. Diseng ag e the PTO , mo v e the motion control

lev ers to the neutral loc k ed position, and set

the parking brak e .

2. Stop the engine , remo v e the k ey , and w ait for

all mo ving par ts to stop before lea ving the

operating position.

3. After adjusting the height-of-cut, remo v e

the ﬂang e n ut, bushing, spacer , and bolt

( Figure 19 ).

Figure 19

1. Outer roller 4. Bolt

2. Spacer

5. Nut

3. Bushing

4. Select a hole so that the outer roller is

positioned to the nearest cor responding

height-of-cut desired ( Figure 19 ).

5. Install the outer roller , bushing, spacer , bolt,

and n ut ( Figure 19 ).

6. T or que the bolt to 40 to 45 ft-lb (54 to 61

N ⋅ m).

Adjusting the Center Rollers