Service Manual

ENGINE

3 - 2 Mid-Mount Z Service Manual

Engine Remove & Replace

Air-Cooled

1. Disconnect the negative battery cable.

2. Remove the PTO clutch anchor bolt from the

clutch guard.

3. Remove the clutch guard and clutch guard

brackets (Figure 20).

Figure 20

1023-011

4. Remove the battery cable, main power feed, and

solenoid wire from the starter solenoid (Figure 21).

Figure 21

1023-008

5. Disconnect the PTO clutch electrical plug and

main wiring harness connector (Figure 21).

6. Release the tension from the drive belt by raising

the lever against the spring tension and remove

the belt from the PTO pulley (Figure 22).

Figure 22

1101-011

7. Remove the clamps securing the choke and

throttle cables. Then remove the Z bends from

the choke and throttle levers (Figure 23).

Figure 23

1023-005

8. Place the fuel tank selector lever in the off position

and disconnect the fuel supply line from the fuel

filter.

(A) Battery Cable/

Power Feed

(B) Solenoid Wire

(D) Main Harness

Connector

(A) Cable Clamps

(B) Throttle Lever