Operator's Manual

Maintenance

10. Slide seat forward, disconnect prop rod and tilt

seat fully forward.

11. Disconnect electrical connector from the seat

safety switch. Temporarily

install a jumper wire

across terminals in the wiring harness connector.

12. Loosen locknut at ball joint on pump control rod

(Fig. 40).

Note: The front nut of each rod has left–hand

threads.

13. Adjust pump rod length by rotating double nuts

on rod, in the appropriate direction, until wheel

is still or slightly creeps in reverse (Fig. 40).

14. Move motion control lever forward and reverse,

then back to neutral. Wheel must stop turning or

slightly creep in reverse.

Note: Motion control lever must be in neutral

while making any adjustments.

15. Open throttle to fast. Make sure wheel remains

stopped or slightly creeps in reverse, re-adjust if

necessary.

16. Repeat on opposite side of unit. T

ighten locknuts

against ball joints.

POTENTIAL HAZARD

• Electrical system will not perform proper

safety shut off with jumper wire installed.

WHAT CAN HAPPEN

• Contact with moving parts may cause

personal injury.

HOW TO AV

OID THE HAZARD

• Remove jumper wire from wir

e harness

connector and plug connector into seat

switch when adjustment is completed.

• Never operate this unit with jumper install

and seat switch by passed.

17. Shut off unit. Remove jumper wire from wire

harness connector and plug connector into seat

switch.

18. Reinstall prop rod and lower seat.