Operator's Manual

Operation
27
Stud Method
1. Disengage the power take off (PTO) and turn the
ignition key to “OFF” to stop the engine. Move
controllers to neutral locked position and apply
parking brake. Remove the key.
2. After adjusting height-of-cut remove nut and
washer while holding stud with wrench
(Fig. 13).
Note: Do not remove the wheel nut and
washer (Fig. 13).
3. Select hole so gage wheel is positioned to the
nearest corresponding height-of-cut desired (Fig.
12).
4. Reinstall the stud nut and washer (Fig. 13).
5. Repeat adjustment on other gage wheels.
m–4161
1
2
3
4
5
Figure 13
1. Gage Wheel
2. Stud
3. Washer
4. Nut
5.
Wheel nut and washer .
Do Not Remove.
Center Rollers
1. Disengage the power take off (PTO) and turn the
ignition key to “OFF”. Move controllers to
neutral locked position and apply parking brake.
1. After adjusting height-of-cut, remove bolt and
nut (Fig. 14).
2. Select hole so gage wheel is positioned to the
nearest corresponding height-of-cut desired
(Fig. 14).
Note: Do not adjust rollers to support the
deck.
3. Reinstall the bolt, center rollers and nut
(Fig. 14).
m–4124
1
2
3
Figure 14
1. Center Rollers and Spacer
2. Nut
3. Bolt