Operator's Manual

Operation
23
Stopping
1. Move the throttle lever to “SLOW” (Fig. 5).
2. Turn the ignition key to “OFF” (Fig. 6).
Note: If the engine has been working hard or
is hot, let it idle for a minute before
turning the ignition key “OFF.” This
helps cool the engine before it is
stopped. In an emergency, the engine
may be stopped by turning the ignition
key to “OFF.”
3. Pull wire off spark plug(s) to prevent possibility
of someone accidentally starting the machine
before transporting or storing machine.
4. Close fuel shut off valve, on front panel before
transporting or storing machine.
IMPORTANT: Make sure fuel shut off valve
is closed before transporting or storing
machine, as fuel leakage may occur. Set
parking brake before transporting.
Operating the Power T ake Off
(PTO)
The power take off (PTO) switch engages and
disengages power to the electric clutch.
Engaging the PTO
1. Release pressure on the traction control levers
and place in neutral, refer to traction unit
Operator’ s Manual.
2. Release the parking brake, refer to traction unit
Operator’ s Manual.
3. Pull out on the power take off (PTO) switch to
engage (Fig. 7).
1
2
m–4201
Figure 7
1. PTO – Of f2.PT O – On
Disengaging the PTO
1. To disengage push the PTO switch to the “OFF”
position (Fig. 7).