Operator's Manual

49
Cleaning and Storage
1. Disengage the power take off (PTO), set the parking
brake and turn the ignition key to off. Remove spark
plug wire. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff from
the outside of the engine’s cylinder head fins and
blower housing.
Important You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, engine, hydraulic pumps and motors.
3. Service the air cleaner; refer to Servicing the Air
Cleaner, page 29.
4. Grease and oil the machine; refer to Greasing and
Lubrication, page 33.
5. Change the crankcase oil and filter; refer to Servicing
the Engine Oil, page 30.
6. Change the hydraulic filter; refer to Servicing the
Hydraulic System, page 34.
7. Check the tire pressure; refer to Checking the Tire
Pressure, page 34.
8. Charge the battery; refer to Servicing the Battery
page 44.
9. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with a
garden hose.
10. Check the condition of the blades. Refer to Servicing
the Cutting Blades on page 27.
11. Prepare the machine for storage when non–use occurs
over 30 days. Prepare machine for storage as follows.
A. Add a petroleum based stabilizer/conditioner to fuel
in the tank. Follow mixing instructions from
stabilizer manufacture. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most effective when
mixed with fresh gasoline and used at all times.
B. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
C. Stop engine, allow to cool and drain the fuel tank;
refer to Servicing the Fuel Tank, page 32.
D. Restart engine and run it until it stops.
E. Choke or prime the engine. Start and run engine
until it will not start. Operate primer, if equipped on
machine, several times to ensure fuel remains in
primer system.
F. Dispose of fuel properly. Recycle as per local codes.
Important Do not store stabilizer/conditioned gasoline
over 90 days.
12. Remove the spark plug(s) and check its condition; refer
to Servicing the Spark Plug, page 31. With the spark
plug(s) removed from the engine, pour two tablespoons
of engine oil into the spark plug hole. Now use the
starter to crank the engine and distribute the oil inside
the cylinder. Install the spark plug(s). Do not install the
wire on the spark plug(s).
13. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
14. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it in
a memorable place out of reach of children or other
unauthorized users. Cover the machine to protect it and
keep it clean.