Service Manual

Install Input Shaft
In
install Bearing Spacer Washer
Install Input Shaft Seal Install Input Shaft Seal
Retaining Ring
If the block spring retaining ring was removed from the
pump shaft, install a new retaining ring onto the shaft.
Install a new inner bearing retaining ring
(if used) onto the
pump shaft. Press the bearing onto the shaft. Install the
washer
(if used) and a new outer bearing retaining ring.
NOTE: Do not stretch or deform the retaining ring.
Install, the pump shaft and bearing assembly into the
housing.
Install the bearing spacer washer.
Wrap the spline or key end of pump drive shaft with thin
plastic to prevent damage to the seal lip during installa-
tion. Lubricate the new pump shaft seal with petroleum
jelly.
Slide the seal over the shaft and press it into the housing
bore. Be careful not to damage seal.
Install the retaining ring.
Page 13