Service Manual

Bypass Valve At Variations
Orienting
Charge Pump Cover (CCW Rotation)
I
Bypass Valve
Unscrew the, bypass valve from the end cap.
NOTE: Some valves have a 5/8" hex end
while others have a cross hole.
Inspect the valve and mating seat in the end cap for
damage or foreign material.
It is recommended that the
O-ring and backup ring be replaced.
Reinstall the bypass valve into the end cap. Torque to
7-
10 ft. lbs.
Charge Pump
The charge pump rotation is determined by the orienta-
tion of the charge pump cover on the end cap. The cast
boss on the Charge pump cover indicates the orientation.
Make note of the correct orientation prior to remov-
ing
the charge pump cover.
Using a 5 mm internal hex wrench, remove the two (2)
screws holding the charge pump cover to the end cap.
Remove the charge pump cover and O-ring.
Remove the charge pump gerotor assembly.
Remove the charge relief valve spring and
ball.
Orienting Charge Pump Cover (CW Rotation)
Page 8 BDP Service Manual