Operator's Manual

Mow at Correct Intervals

Normally, mow every four days. But remember, grass

grows at different rates at different times. So to maintain

the same cutting height, which is a good practice, mow

more often in early spring. As the grass growth rate slows

in mid summer, mow less frequently. If you cannot mow

for an extended period, first mow at a high cutting height;

then mow again two days later at a lower height setting.

Cutting Speed

To improve cut quality, use a slower ground speed.

Avoid Cutting Too Low

If the cutting width of the mower is wider than the mower

you previously used, raise the cutting height to ensure that

uneven turf is not cut too short.

Long Grass

If the grass is ever allowed to grow slightly longer than

normal, or if it contains a high degree of moisture, raise the

cutting height higher than usual and cut the grass at this

setting. Then cut the grass again using the lower, normal

setting.

When Stopping

If the machine’s forward motion must be stopped while

mowing, a clump of grass clippings may drop onto your

lawn. To avoid this, move onto a previously cut area with

the blades engaged.

Keep the Underside of the Mower Clean

Clean clippings and dirt from the underside of the mower

after each use. If grass and dirt build up inside the mower,

cutting quality will eventually become unsatisfactory.

Blade Maintenance

Maintain a sharp blade throughout the cutting season

because a sharp blade cuts cleanly without tearing or

shredding the grass blades. Tearing and shredding turns

grass brown at the edges, which slows growth and increases

the chance of disease. Check the cutter blades daily for

sharpness, and for any wear or damage. File down any

nicks and sharpen the blades as necessary. If a blade is

damaged or worn, replace it immediately with a genuine

Toro replacement blade.