Service Manual

Install Cradle Bearings and Guide Block
Swashplate Kit Components
Install the swashplate cradle bearings into the housing,
making sure they are located on the cast-in pins in the
housing.
Install the slot guide blockonto the displacement control
shaft.
Install the Swashplate into the housing. The slot on the
swashplate must engage the guide block on the displace-
ment control shaft. Use
a tool such as a screwdriver or
magnet to
hold the guide block in position while installing
the swashplate.
Hold the swashplate in position and measure the side
play
of the displacement control shaft using a dial indica-
tor or depth gauge. Using a suitable sleeve, press the
control shaft bearing into the housing until the control
shaft end play is between
0.020 and 0.060 in.
Install the thrust washer and pump cylinder block spring
onto the pump shaft.
Install Swashplate, Thrust Washer and Block Spring
Page 14 BDP Service Manual