Setup Instructions

Step

Installing the Motion

Control Levers

Parts needed for this step:

Qty. Part

1 Control lever–right

1 Control lever–left

4 Bolt, 3/8 x 1 inch (2 assembled)

4 Curved washer, 3/8 inch (2 assembled)

Procedure

1. Rotate the handles

to the upright position.

2. Loosely install the

levers on the outside of

the posts, using 4 bolts

and curved washers.

Note: Install the levers

in the top and middle

holes for the high

position or the middle

and bottom holes for the

low position, as desired.

m–6866

3. In the neutral position, raise the levers, bringing

them together, and slide them until they are aligned,

then tighten the bolts.

m–6867

m–6868