Operator's Manual

Operation
19
Pushing the Machine by Hand
IMPORTANT: Always push the machine by
hand. Never tow the machine because
hydraulic damage may occur.
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to “OFF” to stop the engine.
2. Lift the drive control rods (dump valves), on
front of hydrostatic pumps, up and latch into
hooked slot. This allows hydraulic fluid to
by-pass the pump enabling the wheels to turn
(Fig. 12).
To Operate the Machine
1. Unhook the drive control rods (dump valves)
and drop down into slot to operate (Fig. 12).
Note: The machine will not drive unless
drive control rods (dump valves) are
down in the slots.
2
m–3080
1
2
Figure 12
1. Drive control rod 2. Latch hook