Service Manual

Cylinder block cmp
17.Install two thrust plates(61) onto swash plates
(59). And install oil seal(42), spacer(37) and
ring(41) into housing(27).
And install two control arms(62), two bolts(63)
and two nuts(64) onto swash plates(59). [Fig.18]
18.Cylinder block cmp and piston [Fig.19]
19.Install two cylinder block cmp(51) onto
thrust plates(61). And install pipe(B cmp(36)
into housing(27). [Fig.20]
*When installing, take care of the direction of
thrust plates(61).
*Put clean oil on the contact surfaces of
cylinder block(55) and pistons(52).
*Do not drop pistons(52) when installing
cylinder block cmp(51).
*Avoid damage of surfaces(pistons(52),
cylinder blocks(55) and thrust plates(61)).
*When installing, take care not to damage lip of
oil seal(42).
Fig.21
Fig.19
Fig.18
61
X2
63
X2
64
62
X2
X2
51
Fig.20
51
X2
36
34
X2
27
61
52
41
37
42
34
X2
35
36
Swash plate side
Tightening torque
29.4±2.9Nm
Piston side
7