Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Chassis
- General Information
- Service and Repairs
- Right Console Replacement
- Left Console Replacement
- Throttle Cable Assembly Replacement
- Choke Cable Assembly Replacement
- Seat Replacement
- MYRIDE® Replacement
- Fuel Tank Replacement
- Park Brake Handle Assembly Replacement
- ROPS (Roll Over Protection System) Replacement
- Caster Fork and Bearing Replacement
- Caster Wheel Rebuild
- Motion Control Assembly Replacement
- Chapter 6 : Deck
- Chapter 7 : Drive System
- Chapter 8 : Electrical
- Appendix A: Foldout Drawings
- Electrical Schematic
- Electrical PTO Engaged Schematic
- Electrical Run Position
- Electrical Start Position
ROPS(RollOverProtectionSystem)Removal(continued)
g346263
Figure48
10.Liftthelowertubesawayfromthechassis.
ROPS(RollOverProtectionSystem)Installation
1.Installthelowertubesontothechassis.
2.Installthe4(½inch,2perside)boltsandlocknutssecuringthelowertubes
tothechassis.
g346263
Figure49
CAUTION
UpperROPSassemblyisheavy,assistanceorsupportisneededfor
removal.Personalinjuryordamagemayoccur.
4000SeriesZMASTER®ServiceManual
Page5–27
Chassis:ServiceandRepairs
3442-427RevA