Service Manual

18 ZT-5400 Powertrain
65
66
67
64
56
63
62
54
61
60
59
58
51
Figure 9 Return To Neutral
RETURN TO NEUTRAL ASSEMBLY OPTION
RefertoFigure9
Disassembly
1. Remove all items previously discussed in
their recommended order.
2. Remove the spring (64).
3. Remove the Torx head screw (56) and dis-
card. Remove the washer (63).
4. Remove the scissor arm (62). Remove the
Allen head screw (61), the bushing (60) and
the RTN control arm (54).
5. Remove the neutral arm (59) and the spacer
(58).
NOTE: Onlyremovetheseal(51)andtheRTN
controlarmstrokelimiter(65)ifdam-
agedorworn.Marktheorientationof
thestrokelimiterbeforeremoval.
Inspection
1. Inspect all parts for excessive wear or dam-
age. Replace if necessary.
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. When tightening the fasteners, refer to the
table on page 15 for the required torque
values.
3. Install new Torx head screw (56) and lip seal
(51) from seal kit.
NOTE: Asageneralrule,usethelowendof
the torque specication on fasteners
whenreassemblingtheunit.