Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Chassis
- General Information
- Service and Repairs
- Right Console Replacement
- Left Console Replacement
- Throttle Cable Assembly Replacement
- Choke Cable Assembly Replacement
- Seat Replacement
- MYRIDE® Replacement
- Fuel Tank Replacement
- Park Brake Handle Assembly Replacement
- ROPS (Roll Over Protection System) Replacement
- Caster Fork and Bearing Replacement
- Caster Wheel Rebuild
- Motion Control Assembly Replacement
- Chapter 6 : Deck
- Chapter 7 : Drive System
- Chapter 8 : Electrical
- Appendix A: Foldout Drawings
- Electrical Schematic
- Electrical PTO Engaged Schematic
- Electrical Run Position
- Electrical Start Position
MotionControlAssemblyRemoval(continued)
g337843
Figure51
9.Disconnectthemotioncontrolassemblyfromtheframe.
g336044
Figure52
10.Lowerthemotioncontrolassemblythroughtheframetowardthecenterof
themachine,removetheassembly.
MotionControlAssemblyInstallation
1.Positionthemotioncontrolassemblyinplacewiththelinkageextending
towardthetransmission.
2.Securethemotioncontrolassemblytotheframe.
3.Connectthemotioncontrollinkagetothetransmission.
4.Adjustthenutonthemotioncontrolassemblyuntilthemotioncontrolnutis
centeredinthecontrolplateslots.
4000SeriesZMASTER®ServiceManual
Page5–31
Chassis:ServiceandRepairs
3442-427RevA