Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Chassis
- General Information
- Service and Repairs
- Right Console Replacement
- Left Console Replacement
- Throttle Cable Assembly Replacement
- Choke Cable Assembly Replacement
- Seat Replacement
- MYRIDE® Replacement
- Fuel Tank Replacement
- Park Brake Handle Assembly Replacement
- ROPS (Roll Over Protection System) Replacement
- Caster Fork and Bearing Replacement
- Caster Wheel Rebuild
- Motion Control Assembly Replacement
- Chapter 6 : Deck
- Chapter 7 : Drive System
- Chapter 8 : Electrical
- Appendix A: Foldout Drawings
- Electrical Schematic
- Electrical PTO Engaged Schematic
- Electrical Run Position
- Electrical Start Position
MYRIDE®Removal(continued)
6.Loosen(donotremove)the2(3/8inch)locknutssecuringthelowermount
oftherearshocktotheROPS.
g348060
Figure40
7.Loosen(donotremove)the1/2inchlocknutsecuringthefrontshockupper
mounttotheMYRIDEplatform.
8.Removetheoorpan.
9.Openthe2plasticclampssecuringthefuelandventlines.
g348062
Figure41
10.Removethe4(5/16inch)locknutssecuringthe2(1shownbelow)bearing
bracketstothechassis.
Note:Only1ofthe4locknutsareshownintheimagebelow.
4000SeriesZMASTER®ServiceManual
Page5–21
Chassis:ServiceandRepairs
3442-427RevA