Setup Instructions

Set-Up Instructions
5
4
1
2
3
1254
Figure 5
1. Positive battery post
2. Negative battery post
3. Red (+) charger lead
4. Black (–) charger lead
5. Slowly pour electrolyte into each cell until the
level is once again up to “UPPER” line on the
battery case (Fig. 4), then install the filler caps.
6. Install the battery in the tractor and connect the
battery cables (refer to Installing the Battery in
your tractor Operator’s Manual).
Note: Do not run the tractor with the battery
disconnected.
Installing the Drawbar Hitch
Pin
Insert the drawbar hitch pin into the drawbar hitch
and secure it with a .50” I.D. flat washer and hairpin
cotter (Fig. 6).
2
1
3
m–2481
4
Figure 6
1. Drawbar hitch pin
2. Drawbar hitch
3. .50” Flat washer
4. Hairpin cotter
Checking the W iring and
Fasteners
• Inspect the tractor for any loose electrical
connections and secure them as required. Check
the wire routing to make sure moving parts do
not interfere with wires and cause a short.
• Assure all fasteners are tight.