Service Manual

I
ELECTRICAL SYSTEM 7-15
jL
Igniter Inspection
ORemove the igniter.
0 Unfasten the igniter lead connectors.
0 Unscrew the mounting screws and remove the igniter.
A. Igniter
B. Lead Connectors (4P Couplers)
C. Mounting Screws
@To inspect the igniter resistance, perform the following.
l Set the KAWASAKI multimeter selector switch to the R x 1 kf2
position.
l Connect the test leads to the points shown on the chart and drawing
and read the resistance.
*If the meter readings are not as specified, replace the igniter.
ACAUTION
Use only Kawasaki hand tester (special tool: 57001883) for this test.
A tester other than the Kawasaki hand tester may show different
readings.
If a megger or a meter with a large-capacity battery is used, the
igniter will be damaged.
L
Meter Range : kn
Ambient Temperature (20 “C)
(-1’ 5 a, al
0 1-6 l-6 0 0.5 - 2
6 00 00 1-6 3 -15 0.5 - 2 - 1-6
1-6
7 00 00 0 1 -6 2-8 l-6 - 0.5 - 2
8 00 00 0.5 i. 2 2 - 8 0.5 - 2 2 - 8 0.5 - 2
-
(-)“: Tester (-) Terminal (Black)
I
Wire Color
I
I w:
White
1 E- Bla%/yellow
I
1 BW: Black/White
I
OW: Orange/White
I