Service Manual

TAILLIGHTS
Bulb Removal
1. Remove the taillight assembly from the
fender.
2. Rotate the bulb holder 1/4 turn
counterclockwise and remove it from the
housing.
3. Push and rotate the bulb counterclockwise
until it stops (approximately 1/4 turn).
Bulb Number: GE 194
ELECTRIC CLUTCH TROUBLESHOOTING
General Information
Equipment Needed: Volt/Ohm and Ampmeter
The following troubleshooting steps will help
you determine if the clutch has failed or is the
cause of the electrical problem.
Coil Resistance Measurement
Equipment: Volt/Ohmmeter
1. Disengage the PTO, set the parking brake,
turn the ignition key to OFF, and remove the
key.
2. Disconnect the clutch wire connector.
3. Set the volt/ohmmeter to check resistance
(ohms).
2.0144.080
2.0144.006
2.0757.027
6
ELECTRICAL
6-8 5xi Series Tractor Service Manual