Service Manual

Tighten the rear jam nut first. Hold the front
rod end fitting while tightening the front jam
nut.
IMPORTANT: There must be axial
looseness in the rod (A) or there may be
binding in the pedal linkages.
Test the adjustment by cycling the brake.
The slot should travel over bushing (A)
without touching.
4. Check the neutral adjustment. If the tractor
creeps in neutral, adjust the motion control
lever following the procedure on page 3-8,
Neutral Adjustment in the Hydrostatic Drive
section of this manual.
2.7233.073
2.0144.072
2.0144.089
2
CHASSIS
5xi Series Tractor Service Manual 2-19