Service Manual

CHASSIS

3-7Toro Z Master G3 3000/5000/6000 Series Service Manual

Front Wheel Bearing Installation

8. Remove the 2 tapered bearings from the wheel

assembly (Fig. 023).

1. Install a new tapered bearing cup into the wheel

assembly by pressing each bearing cup into the

wheel hub so that the thicker part of the taper is

pressed into the wheel hub rst. The bearing cups

should seat against the shoulder divots inside the

wheel hub (Fig. 025).

Fig. 023 PICT-0385a

9. Drive the bearing cup out of the wheel assembly

(Fig. 024).

Fig. 024 PICT-0387a

Fig. 025 PICT-0389a

2. Pack both tapered bearings with grease (No. 2

general purpose lithium base or molybdenum

grease).

3. Install the tapered bearings into each side of the

wheel hub (Fig. 026).

Fig. 026 PICT-0390a