Service Manual

CHASSIS
3-47Toro Z Master G3 3000/5000/6000 Series Service Manual
3
14. Plug the wire harness to the park brake switch (Fig.
169).
Fig. 169 DSCN-2617a
15. Install the two screws retaining the right hand
motion-control cover assembly to the frame (Fig.
170).
Fig. 170 DSCN-2614a
16. Install the rear tires and torque lug nuts between
103.5 – 126.5 ft-lbs. (140.5 – 171.5 Nm).
17. Remove the jack stands and lower the unit.
Brake Caliper Replacement
Brake Caliper Removal
Fig. 171 DSCN-4314a
Note: The left side is being removed; use the same
instructions for right side removal.
1. Raise the rear end of the unit and install jack stands
under the tie down loop on the frame. Remove the
wheel.
2. Disengage the park brake lever.
3. Remove the e-ring, washer, and brake pin from the
L-Bracket (Fig. 171).