Service Manual

CHASSIS

3-40 Toro Z Master G3 3000/5000/6000 Series Service Manual

12. Hold the end of the threaded rod with a tool and

adjust the lock nut until the spring length is between

1-1/2” and 1-9/16” (3.8 and 4.0cm) (Fig. 145).

Note: Do not allow the cable to turn when the nut

are being turned.

Fig. 145 DSCN-4315a

16. Plug the wire harness to the park brake switch (Fig.

146).

13. Disengage the parking brake. Rotate the drive wheel

release handle to the released position. Turn the

wheel hub by hand in both directions relative to the

caliper; no drag of the caliper pad on the wheel hub

is desired.

14. After adjusting the brake, cycle the brake handle a

minimum of six times to allow the cable to seat into

the sheath and mounting tabs. Recheck the spring

length.

15. Rotate the drive wheel release handle to the

operating position.

Fig. 146 DSCN-2617a

18. Install the rear tires and torque lug nuts between

103.5 – 126.5 ft-lbs. (140.5 – 171.5 Nm).

19. Remove the jack stands and lower the unit.

17. Install the two screws retaining the right hand

motion-control cover assembly to the frame (Fig.

147).

Fig. 147 DSCN-2614a