Service Manual

MOWER DECKS

6-23Toro Z Master G3 3000/5000/6000 Series Service Manual

Deck Leveling

Note: Ensure the mower deck is leveled before

matching the height-of-cut (HOC).

1. Position the mower on a at surface.

2. Stop engine, wait for all moving parts to stop, and

remove key. Engage parking brake.

3. Check the tire pressure in the drive tires. Proper

ination pressure for tires is 13 psi (90 kPa). Adjust

if necessary.

4. Position the transport lock in the latching position.

5. Push the deck lift pedal all the way forward and the

deck will latch at the 5 1/2” (14cm) transport position

(Fig. 454).

6. Insert the height adjustment pin into the 3” (7.6cm)

cutting height location.

7. Release the transport lock and allow the deck to

lower to the cutting height.

8. Raise the discharge chute.

9. On both sides of the deck, measure from the level

surface to the front tip of the blade (Position A). The

measurement should read 3” (7.6mm) (Fig. 455).

Fig. 454 g. 92 G017027

Fig. 455 g. 93 G009196

A. Deck lift pedal C. Transport lock

B. Height -of-cut pin

1. 3” (7.6cm) at A is 3. Measure here from

correct the blade tip to hard

2. 3-1/4” (8.3cm) at B surface

is correct 4. Measure at A & B on

both sides

Leveling the Mower Deck