Service Manual

HYDRO-GEAR TRANSAXLE
3 - 4 400XT Series Tractor Service Manual
13. Remove the two nuts and washers that are
located on each side of the transaxle axle housing
holding the transaxle to the frame (Figure 128).
Figure 128
MVC-073F
14. Slowly lower the transaxle slightly and STOP. You
will need to disconnect the hydro rod from the
cruise control plate. Remove the cotter pin and
washer (Figure 129).
Figure 129
MVC-074F
15. Continue to lower the transaxle out of the tractor
frame (Figure 130).
Figure 130
MVC-077F
Installation - Hydro-Gear Transaxle
1. Raise the transaxle up toward the frame allowing
enough room to install the hydro rod to the cruise
plate and secure with a cotter pin and washer
(Figure 129).
2. Secure the transaxle to the frame brackets with
four carriage bolts, washers, and nuts (Figure
131).
Figure 131
MVC-078F