Service Manual

HYDRO-GEAR TRANSAXLE
3 - 12 400XT Series Tractor Service Manual
6. Route the belt over the lift bar assembly (Figure
155).
Figure 155
MVC-785F
7. The belt then goes forward over the hydro pivot
shaft and steering sector (Figure 156).
Figure 156
MVC-786F
8. Route the drive belt around the flat and v-idler
pulleys and then around the engine drive pulley
(Figure 157).
Figure 157
MVC-787F
9. Go back to the transaxle pulley and install the belt
around the pulley.
10. Check the routing of the belt around both the
engine and transaxle pulleys, the front flat and v-
idlers and the rear flat and v-idler pulleys (Figure
158).
Figure 158
belt routing top