Operator's Manual

Operation
17
Indicator Control Module
The indicator control module (Fig. 9) contains lights
for:
• Operating–in–Reverse
• Power take off (PTO)
• Battery
• Hourmeter
• Oil pressure
• Fuel level
7531 42 6
Figure 9
1. Power take of f (PT O)
2. Temperature
3. Battery
4. Hourmeter
5.
Fuel Level
6. Oil
7. Operating–in–Reverse
Following are the conditions when indicator lights
will be “ON”. At other times the lights should be off.
Operating–in–Reverse
The Operating–in–Reverse light will illuminate
whenever the “key choice” switch is used to
deactivate the operating–in–reverse interlock. It is a
reminder that the interlock system is deactivated.
The light goes out whenever the power take off (PTO)
is disengaged or the engine is shut off.
PTO (Power Take Off)
The PTO (power take off) light will be “ON” when
the key is in the “RUN” or “LIGHTS” positions and
the PTO (power take off) is engaged “ON”. When
this light is “ON” it is a reminder; the starter will not
crank and turn off the PTO before getting off.
Hourmeter
The hourmeter records the number of hours the
engine has operated (Fig. 9). It is turned on when the
ignition switch is in the “RUN” or “LIGHTS”
positions. Use the times for scheduling regular
maintenance.
Battery
The battery light will be “ON” when the key is in the
“RUN” or “LIGHTS” positions if the battery voltage
is below 12.6 volts or when the engine is running and
the alternator output is above 14.8 volts. When this
light comes on it is important to have your battery
and electrical system checked and the problem
corrected.
Fuel Level
The fuel level light will be “ON” when the key is in
the “RUN” or “LIGHTS” positions and the fuel level
is low, approximately one pint remaining.
Oil
The oil light will be “ON” when the key is in the
“RUN” or “LIGHTS” positions and the engine is not
running, after the engine is started the light should go
out. When the engine is running if the oil pressure
drops below a safe operating level the light comes
“ON”. When the light comes on while the engine is
running, Stop engine immediately and correct the
cause of low oil pressure.