Service Manual

11Tuff Torq Model K61A Hydrostatic Transaxle Transaxle Disassembly and Inspection
Remove the shift blocks from the control shaft and
inspect them for wear or damage. Replace if necessary.
Figure 28
Figure 29
Remove the two metal thrust pads from the upper case
and inspect them for wear or damage.
Replace both thrust pads with new parts if the maximum
wear limit is exceeded.
Table 4
Measurement
Should be:
Thickness 1.45-1.55mm
(.057-0.61″)
Maximum Wear Limit 1.30mm (.051″)
Remove the input shaft, seal, and bearing from the upper
case. R emove oil seal and large snap ring from the upper
case. Remove the input shaft and bearing from the case.
Figure 30
Figure 31
Figure 32