Service Manual

310-3000 IHT 15
Figure 7. Brake Pull Rod Assembly Adjustment
INSPECTION
1. Inspect the brake pucks (120) for excessive
wear.
2. Replace with new if necessary.
ASSEMBLY
1. Install inner brake puck (120), and brake disc
(85).
2. Assemble the brake yoke assembly, by in-
stalling puck plate (131), outer brake puck
(120) into brake yoke (122).
3. Install the brake yoke assembly onto two
mounting studs on housing assembly (2). Use
of a feeler gage (0.015”) may be helpful in
retaining the brake yoke assembly at this
step.
4. Install at upper bolt spacer (130), washer
(139), lock washer (126), and nut (127).
5. Install at lower bolt lock washer (126), and
nut (127) to secure the brake yoke assem-
bly.
6. Install brake anti-drag compression spring
(151), and two brake pins (125).
7. Install brake arm (124) onto brake yoke as-
sembly.
8. Install washer (77), and castle nut (128).
9. Insert a (0.015”) feeler gage between brake
disc (85) and top brake puck (120). Adjust
the brake by turning castle nut (128) until it is
snug but not tight against the feeler gage. (The
brake gap must be adjusted to a (0.015”)
clearance.
10.Install cotter pin (129) to secure castle nut
(128).
11. Install brake arm bias spring (141) to brake
arm (124) and top brake arm bolt.
12.Install brake pull rod (152) into brake arm
(124) and actuating arm (35).
13.Secure brake rod (152) to actuating arm (35)
by installing washer (77) and cotter pin (129).
14.Secure brake pull rod (152) to brake arm by
installing washer (77), brake spring (134),
washer (77), and lock nut (95). Set to the di-
mension shown in Figure 7.