Service Manual

16 Tuff Torq Model K61A Hydrostatic TransaxleTransaxle Disassembly and Inspection
Remove the snap rings, washer, bearing, and seal from
the motor shaft (brake shaft).
Note:
Do not remove the bearing unless it needs to be
replaced. It is a press fit and will likely be damaged in the
process of removing it.
Figure 53
Inspect the motor shaft and bearing for wear or damage
and replace if necessary.
Figure 54
Pump Shaft
Remove the two snap rings, washer, and bearing from
the pump shaft.
Note:
Do not remove the bearing unless it needs to be
replaced. It is a press fit and will likely be damaged in the
process of removing it.
Figure 55
Inspect the bearing and pump shaft for wear or damage
and replace if necessary.
Figure 56