Service Manual

310-3000 IHT 25
73
65
76
70
C
D
A
B
96
61
62
60
71
2
118
119
80
59
119
118
1
117
70
76
65
73
68
64
66
67
63
66
58
C
D
A
B
REF. Part Name
1 Main Housing
2 R.H. Housing Assembly
58 Carrier Pin
59 Planetary Gears
60 67t Spur Gear
61 21t Sun Gear
62 Planetary Thrust Plate
63 51t Ring Gear
64 Planetary Carrier
65 Differential Miter Gear
66 Differential Miter Gear
67 Differential Shaft
68 Differential Thrust Plate
REF. Part Name
117 Housing Pin
118 Axle Hub Assembly
119 Hex Nut
REF. Part Name
70 Washer
71 Washer
63 51t Ring Gear
64 Planetary Carrier
65 Differential Miter Gear
66 Differential Miter Gear
73 Hex Jam Nut
76 Axle Shaft
80 Torx Head Screws
96 Bearing Sleeve
Figure 15. Planetary Differential Assembly
11. Install the planetary thrust plate (62).
12.Install the 67T spur gear (60) onto the 21T
sun gear (61).
13.Slide washer (71) onto axle shaft (76).
14.Install the two housing pins (117) into the main
housing (1).
15.Apply a bead of sealant to the R.H. housing
(2).
16.Install R.H. housing (2) by sliding it down the
axle shaft (76), over motor shaft assembly
(24, Figure 15) and onto main housing (1).
17.Secure housings by installing the eight hous-
ing screws (80), per Table 5, Page 13.
18. After the transaxle has been installed in the
vehicle, install the axle hub assemblies (118),
according to the instructions in “Transaxle in-
stallation”, Page 30.