Operator's Manual

Maintenance
32
Transaxle Fluid
Service Interval/Specification
The transaxle is a sealed system and no checking or
changing of the fluid is required.
IMPORTANT: If any transaxle problems
arise, contact your local Authorized Service
Dealer for help and service.
Fuse
Service Interval/Specification
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short. To
replace fuses pull up on the fuse (Fig. 33) to remove
or replace it.
Fuse: Main/Starter F1–30 amp, blade-type
Regulator F2–25 amp, blade-type
Dash F3–10 amp, blade-type
Head lights F4–10 amp, blade-type
1
2344
2
3
4
Figure 33
1. Dash-10 Amp
2. Head lights-10 amp
3. Regulator-25 amp
4. Main-30 amp
Headlights
Specification: Bulb # 1156 Automotive Type
Removing the Bulb
1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
“OFF” to stop the engine. Remove the ignition
key.
2. Open the hood. Pull wire connectors off both
bulb holder terminals.
3. Rotate the bulb holder 1/4 turn counterclockwise
and remove it from the reflector (Fig. 34).
4. Push and rotate the bulb counterclockwise until
it stops (approx. 1/4 turn) and remove bulb from
the bulb holder (Fig. 35).
1
2
3
4
4
5
5
Figure 34
1. Bulb holder
2. Reflector
3. Tabs
4. Slots
5. Terminals