Service Manual

19Tuff Torq Model K61A Hydrostatic Transaxle Transaxle Assembly and Adjustment
Neutral Adjust Eccentric
Place new packing (o-ring) on the neutral adjust
eccentric.
Note:
Apply grease to packing before installation.
Figure 68
Apply a light film of grease into the hole on the upper
case and insert the neutral adjust eccentric into the upper
case.
Figure 69
Place new packing (o-ring) and torsion spring on the
control shaft.
Note: Apply grease to packing before installation.
Figure 70
Install the control shaft in the upper case and position the
torsion spring as shown.
Figure 71
Drive the roll pin through the hydrostatic control arm and
control shaft.
Figure 72
Install the washer and nut on the neutral adjust eccentric.
Figure 73