Service Manual

14
310-3000 IHT
BRAKE ASSEMBLY
Refer to Figures 6 and 7.
DISASSEMBLY
The following procedure is for model 324-3000.
Reference microfiche for other models.
1. Remove lock nut (95), washer (77), brake
spring (134), and washer (77) from brake pull
rod (152).
2. Remove cotter pin (129), and washer (77)
from brake pull rod (152).
3. Remove brake pull rod (152) and set aside.
4. Remove the cotter pin (129), castle nut (128),
and washer (77).
5. Remove brake arm (124), and brake arm
bias spring (141).
6. Remove brake anti-drag compression spring
(151), and two brake pins (125).
7. Remove upper nut (127), lock washer (126),
washer (139), and spacer (130) which secure
brake yoke assembly (122).
8. Remove lower nut (127), and lock washer
(126) securing brake yoke assembly (122).
9. Remove brake yoke assembly (122), puck
plate (131), and outer brake puck (120).
10.Remove brake disc (85), and inner brake
puck (120).
Figure 6. Brake Assembly
REF. Part Name
127 Nut
128 Castle Nut
129 Cotter Pin
130 Spacer
131 Puck Plate
134 Brake Spring
139 Washer
141 Brake Arm Bias Spring
151 Anti-Drag Compression Spring
152 Brake Pull Rod
REF. Part Name
2 Right Hand Housing Assembly
77 Washer
85 Brake Disk
95 Lock Nut
120 Brake Puck
122 Brake Yoke Assembly
123 Square Head Bolt
124 Brake Arm
125 Brake Pin
126 Lock Washer