Setup Instructions

Set-Up Instructions
2
Install Front Wheels
Note: If wheels are already installed, refer to
Check Tire Pressure (below).
1. Slide wheel onto axle with valve stem in.
(Fig. 1).
2. Wheel end play should be 0-.015” (0-.4 mm).
Use shim washers (as required) and large OD flat
washer for spacing on the axle. Insert cotter pin
through the axle and bend the ends of the pin
open (Fig. 1).
3. Push the dust cover (Fig. 1) onto the end of the
axle so it snaps over washer.
3
5
1
2
4
6
Figure 1
1. Wheel
2. Shim washers (as
required)
3. Large OD flat washer
4. Cotter pin
5. Dust cover
6. Hub cap (optional)
4. Repeat steps 1–3 on opposite side.
5. Grease the wheel bearings.
6. Install hub caps, optional on some models.
Install Rear Wheels
1. Install wheel onto axle with valve stem to the
inside (Fig. 2).
2. Torque wheel bolts to 75-80 ft-lb (105-112 N
.
m).
3. Install hub caps, optional on some models.
1278 2
1
3
Figure 2
1. Wheel
2. Wheel bolts
3. Hub cap (optional)
Check Tire Pressure
Check front and rear tire pressure. See Operator’s
Manual for specification.
Pressure: 12 psi (.85 kPa) front and rear.