Service Manual

8
310-3000 IHT
BRAKE MAINTENANCE
BRAKE SETTING
1. Remove the brake arm bias spring, and then
the cotter pin securing the brake castle nut.
2. Insert a 0.015" feeler gage between the brake
disc and top brake puck, and then set the
brake by tightening or loosening the castle
nut.
3. Adjust brake gap to 0.015" clearance.
4. Install the cotter pin to secure the castle nut,
and then install the brake arm bias spring.
RETURN TO NEUTRAL SETTING
(OPTIONAL FEATURE)
The return to neutral mechanism on the transmis-
sion is designed to set the directional control
into a neutral position. An optional feature, it is
available in two versions. One version provides
hand control, and the other, foot control. Setting
procedures are provided on pages 9 and 10.
WARNING
POTENTIAL FOR SERIOUS INJURY
Certain procedures require the vehicle
engine to be operated and the vehicle to
be raised off of the ground. To prevent
possible injury to the servicing techni-
cian and/or bystanders, insure the ve-
hicle is properly secured.