Service Manual

GEAR DRIVE
5 - 10 260 Series Tractor Service Manual
13. There is a belt guide located in the mid-section of
the tractor. Make sure the belt gets routed
through the wire guide (Figure 200).
Figure 200
MVC-277X
14. Install the cotter pin and washer for the shift lever
rod (Figure 201).
Figure 201
MVC-273X
15. Reinstall the clutch/brake cross shaft and tighten
the brackets (Figure 202).
Figure 202
MVC-271X
16. Install the screw to the safety switch and make
sure the switch is adjusted in the closed position
(Figure 203).
Figure 203
MVC-270X
17. Install the belt around the transaxle input pulley.