Service Manual

260 Series Tractor Service Manual 3 - 11
TUFF TORQ TRANSAXLE
17. Reattach the brake rod return spring, located
under the center access plate (Figure 100).
Figure 100
MVC-352X
18. Bolt the hydrostatic control rod to the forward/
reverse control pedal.
NOTE: Before tightening the bolt, check the pedal
adjustment (Figure 101). Refer to “Foot Control
Adjustment Procedure” on page 3 - 16.
Figure 101
MVC-345X
19. Check the belt tension. If adjustment is needed,
refer to “Belt Adjustment” on page 3 - 13.
20. Reroute the PTO clutch wire through the frame
and tie strap the wire to the frame. Connect the
PTO clutch wire back into the plug. Install the
battery drain tube in the tie strap (Figure 102).
Figure 102
MVC-361X
21. Reconnect the steering tie rods to the steering
sector gear (Figure 103).
Figure 103
MVC-362X