Setup Instructions

6
8. Rotate the adjusting puck (Fig. 8) in both directions
until you find the midpoint where the axle no longer
rotates forward or reverse.
9. Hold the puck with an adjustable wrench so that it will
not move; then tighten and torque the adjusting puck
screw to 21 to 27 ft-lb (28 to 36 N⋅m).
10. Stop the engine and remove the ignition key.
11. Lower the tractor from the jack stand.
12. Check the adjustment again by repeating step 1.
Checking the Traction Control
Pedal
You can adjust the traction control pedal for optimum
forward and reverse speeds.
1. Loosen the screws below the right footrest.
2. Slide the pedal forward for faster reverse speed or
backward for faster forward speed (Fig. 9).
1
2
1909
Figure 9
1. Traction control pedal 2. Adjusting screws
3. Tighten the screws and check the traction control pedal.
Test Drive the Tractor
Ensure that all electrical and mechanical systems are
operating properly. See the Operator’s Manual for proper
control function.