Service Manual

XL GEAR DRIVE
2 - 6 XL Lawn Tractor Service Manual
8. Install the rear hitch panel. There are two bolts,
washers, and nuts on each side of the plate and 2
bolts, washers, and nuts for the seat springs
(Figure 23).
Figure 23
mvc-795
9. Install the right and left rear tires. Install the
battery and battery box. Note: Make sure the
battery drain tube is installed through the rear hole
of the frame (Figure 24; rear hitch panel removed
for clarity).
Figure 24
mvc-639
10. Check the following items:
A. The Shift-On-The-Go for proper adjustment. If
adjustment is needed, (refer to “Cable
Adjustment, Shift-On-The-Go, 915 and MST-
205 Transaxle” on page 2 - 19).
B. Brake Adjustment. If adjustment is needed,
(refer to “XL Gear Drive Brake Adjustment -915
Transaxle” on page 2 - 11).
C. Shift Lever Adjustment. If adjustment is
needed, (Refer to “XL Gear Drive Shift Lever
Adjustment - 915 Transaxle” on page 2 - 9).
11. Install mower deck; see instructions in the Mower
section.
12. Check all safety switches to make sure they are
operating properly.
XL Gear Drive Traction Drive Belt
Replacement Procedure - 915
Transaxle
1. Disconnect battery and remove battery and
battery tray. Remove mower deck. (Refer to
Mower section.)
2. Remove the rear hitch panel. There are 2 bolts
and nuts holding the seat springs and 2 bolts and
nuts on each side of the rear panel (Figure 25).
Figure 25
mvc-795