Setup Instructions

7
Checking the Traction Control
Pedal
For Hydro Drive Tractors only
You can adjust the traction control pedal for optimum
forward and reverse speeds.
1. Loosen the screws below the right footrest.
2. Slide the pedal forward for a faster reverse speed or
backward for a faster forward speed (Fig. 10).
1
2
m-1909
Figure 10
1. Traction control pedal 2. Adjusting screws
3. Tighten the screws.
4. Check the traction control pedal.
Checking the Shift Cable
Adjustment
For Gear Drive Tractors only
Adjust the shift cable if either the ground speed lever does
not shift firmly toward the numbers on the shift plate
when you release the lever or if it is difficult to shift
on-the-go (Fig. 11).
1
2
m-1879
Figure 11
1. Ground speed lever 2. Numbers
1. If either of the above conditions exist, turn the engine
off and ensure that the belt guides are no more than 1/8
inch away from the engine and the transmission
pulleys.
2. Check the cable tension. The cable should be taught
and have 1/2 in. (13 mm) movement when you apply a
slight pressure to the cable (Fig. 12).
2
1
1910
Figure 12
1. Cable 2. Cable guide
3. Move the ground speed lever and note the gap between
the lever and the edge of the gate. There should be
about 1/4 in. (6 mm) of free play before the cable is
taught.
4. Adjust the cable tension by loosening the front cable
guide located on tractor brace above the pulley.
5. Slide the guide sideways as needed, for proper tension
(Fig. 12).
Test Driving the Tractor
To ensure that all electrical and mechanical systems are
operating properly, see the Operator’s Manual.