Service Manual

Assembly

Procedures

Lubricate the running faces and install the motor block

kit

onto the motor shaft.

Install Motor

Block

Kit

Position the washers and seal and install the center

section assembly onto the aligning pins and pump input

shaft.

Insert the three assembly bolts into the center section

and press center section down onto the aligning pins and

pump input shaft until seated on mounting bosses. While

holding the center section in position, toque the bolts

evenly from

525

in.lbs. to

700

in.lbs..

Install Center Section Assembly

Install the motor thrust bearing (with the thicker race

towards the pistons) by compressing the piston springs

and sliding the bearing assembly in to place.

NOTE:

The tool being shown

an example

what you

will

need to compress the pistons and

allow

the bearing

to be installed.

Position Center Section Assembly

Install Motor Thrust Bearing

Page

0-0500/0750

IHT