Service Manual

Assembly Procedures
Position the lower housing onto the upper housing and
secure with assembly bolts. Toque the bolts from
135
in.lbs to 165 in.lbs. following the patterns illustrated
below.
NOTE: The group of bolts around the front of the hous-
ings have the same sequence number because they are
installed simultaneously at our factory, the order in which
you torque them should not be important.
suggested
10-0500 Bolt Torque Sequence
suggested
Bolt Torque Sequence
310-0750 Bolt Torque Sequence
After torquing all bolts, wipe off any excess sealant from
the seam of the housings.
Reposition the transaxle assembly and check the bypass
actuator and axle shafts for freedom of movement. The
axle shafts should not lock up but may be tight, while the
bypass actuator must rotate freely.
Torque the nut on the brake bolt from
120 to 185 in. Ibs..
Tighten Brake Bolt Nut
Install a new lip seal on the displacement control shaft &
bypass actuator as described in the Minor Repairs Sec-
tion.
Install the brake pins and brake arm.
Install the washer and adjustment nut.
Adjust the brake clearance as described in the Minor
Repairs Section.
Refer to the Minor Repairs Section before installing the
control arm and friction pack.
Brake and Control Arm Components
Install the bypass actuator arm and retaining ring. Use
care to avoid over extending the retaining ring.
Page 18
310-0500/0750IHT