Service Manual

MOWER
6 - 20 XL Lawn Tractor Service Manual
17. Check that blade brake pads contact pulleys and
actuating rods are loose when blade control (PTO)
is disengaged, and that brake pads are away from
pulleys when blade control (PTO) is engaged;
refer to "Adjusting Blade Brakes" on page 6 - 22.
Figure 236
1801-2
18. Move the height-of-cut lever (deck lift) into the “D”
notch to make it easier to install the height-of-cut
lift assist spring.
19. Hook the lift assist spring between the mower right
side lift bracket and the retaining bolt (Figure 237)
Use the spring tool provided with the machine.
Figure 237
1851
20. Check mower level; refer to "Side-to-Side Mower
Leveling" on page 6 - 22, and "Front-to-Rear
Blade Slope" on page 6 - 23.
Installing 44” Recycler Baffle
1. Thoroughly clean the mower. All debris must be
removed to ensure baffle will fit properly against
cutting chamber.
2. Place the left side baffle inside cutting chamber.
Secure the baffle to mower with 1-1/4” bolts
through baffle and outside of deck (Figure 238).
Secure with 5/16” lock nuts.
3. Tighten all mounting hardware securely.
(A) Blade Control Cable
(B) Mounting Bracket Slot
(C) Cable Z End
(D) Idler Arm
(E) Jam Nut
(F) 3-1/2” (89mm) Engaged
(A) Spring
(B) Bolt
(C) Spring Tool