Service Manual

Assembly Procedures
Fill the axle pockets of the upper housing with Rykon
Premium grease (inside of bearing location). NOTE: This
grease is not compatible with all grease types.
Do not overfill, and wipe off any excess grease or sealant
will not cure properly.
Install the washers and seals onto the differential / axle
assembly
and align them for installation.
Install the differential / axle assembly into the housing.
Fixture the lower housing and apply the sealant as shown
in the following
two examples.
NOTE: The drawings below may not appear the same as
the factory sealant application, but are the recom-
mended patterns. Apply sparingly.
NOTE: Sealant must be of good quality, oil and heat
resistant.
Install Differential
/ Axle Assembly
3109500 Sealant Application
Install a
new filter onto the center section / check valve
plate.
Install the rotors and stators. Install a stator, then a rotor
(hub to inside), then a stator, then a rotor (hub to inside),
then
two stators.
Install the brake
bolt (with nut) into the upper housing.
3109750 Sealant Application
Install
Brake Components
31 0-0500/0750 IHT
Page 17