FORM NO. 3321–897 WHEEL HORSE LAWN TRACTOR FOR 32” AND 38” MOWERS SET-UP INSTRUCTIONS Loose Parts Note: Use the chart below to verify all parts have been shipped. DESCRIPTION QTY. USE Front Wheel 2 Shim Washer (as required) 2 Flat Washer 2 Cotter Pin 2 Hub Cap 2 Steering Wheel 1 Spirol Pin 1 Seat 1 Knob 1 Flat Washer 1 Wire Clip (on seat pan) 1 Bolt 1/4–20 x 3/4” 2 Wing nut 2 Spring Hook 1 Used to install lift assist spring.
Install Front Wheels Note: Install Steering Wheel If wheels are already installed, refer to Check Tire Pressure (below). 1. Move front wheels straight ahead. 2. Slide the steering wheel over shaft. Line up the hole in the steering wheel with the hole in the shaft (Fig. 2). From the seat you should be able to read the brand logo on the steering wheel. 1. Install shim washers onto axle. 2. Install wheel onto axle with valve stem out. 3. Slide the flat washer onto the axle.
Set-Up Instructions 3. Thread the knob and flat washer into the rear center hole in the seat (Fig. 3). Adjust the seat and tighten the knob. 4. Push the seat switch connector fully into the wire harness connector (Fig. 3). 5. Secure the seat switch wire cable to seat base with wire clip (Fig. 3). Note: POTENTIAL HAZARD • Battery electrolyte contains sulfuric acid which is a deadly poison and it causes severe burns.
3. Leave the filler caps off and connect a 3 to 4 amp battery charger to the battery posts (Fig. 5). Charge the battery at a rate of 4 amperes or less for 4 hours (12 volts). 6. Install the battery and battery box in the tractor: refer to the Operator’s Manual, Installing the Battery. Fill Crankcase with Oil 4 The tractor is shipped from the factory without oil in the engine crankcase: refer to the Operator’s Manual, Engine Oil Specifications for oil type, viscosity, and crankcase capacity.
Set-Up Instructions Check Safety System Check Hydro Neutral Position (Hydro Drive Tractors Only) Refer to the Operator’s Manual, Checking Safety System. Adjustment is required if the tractor creeps without the traction control pedal being depressed. Purge Hydro Transaxle (Hydro Drive Tractors Only) 1. During handling and shipping air can be introduced into the hydro transaxle. To achieve proper performance all trapped air must be removed.
Check Traction Control Pedal (Hydro Drive Tractors Only) Check Shift Cable Adjustment (Gear Drive Tractors Only) After adjusting the hydro neutral position it is necessary to check the traction control pedal. Shut the engine off and check the following. While pressing the control pedal full forward and full reverse the pedal must not contact the footrest pad before hitting the stop(s) at the transaxle (Fig. 7).
Set-Up Instructions 3. 4. Move gear select lever and note gap between lever and edge of gate. There should be about 1/4 inch of free play before cable is taught. To adjust the cable tension loosen the front cable guide, located on tractor brace above deck pulley. Slide guide sideways as required for proper tension (Fig. 10). 2 Test Drive the Tractor Make sure all electrical and mechanical systems are operating properly. See Operator’s Manual for proper control function.