Service Manual

XL Lawn Tractor Service Manual 6 - 3

MOWER

Important: Do not bend the belt guide(s) away from

the pulley. There must be a maximum 1/8” (3mm)

between the belt guide(s) and the edge of the pulley to

keep the belt on the pulley during operation. If the

space is more than 1/8” (3mm), adjust the belt guide(s)

and tighten them securely. The belt guide(s) must not

contact the pulley.

5. Install the mower pivot mount brackets to the front

axle with bolts and locknuts (Figure 201).

Figure 201

m-1888

6. Move the height-of-cut lever into the “A” notch.

7. Slide the end of the long rod through the hole in

the mower mount (Figure 202). Install the washer

and hairpin cotter to secure the rod in place.

Repeat this step on the opposite side of the

mower.

Figure 202

m-1851

8. Mount the slotted mower leveling bracket onto the

pin on the height-of-cut arm (Figure 202 ). Install

the washer and hairpin cotter to secure the

mower. Repeat this step on the opposite side of

the mower.

(A) Pivot Mount Brackets

(A) Rod

(B) Hairpin Cotter & Washer

(D) Mower Mount