Operator's Manual

8

      

An adjustment to the gear shift guide may be
required if the gear shift will not go into the neutral
position.
 Remove cotter pin from rod on right side of
transaxle as viewed from the rear of the unit
(Fig. 32).
 Lift rod out of bracket hole (Fig. 32).
+)52' 
    
 
 Rotate rod one complete turn clockwise and
reinsert rod into hole in bracket.
 Move gear shift selector into REVERSE position,
then to NEUTRAL, then to first gear and then back to
NEUTRAL.
 Try rolling the rider backward and forward.  If
wheels turn freely and gear shift selector lines up
with the NEUTRAL mark on the gear shift guide, the
adjustment is correct.
 If adjustment is not correct, remove rod from
hole in bracket again.  Rotate rod two turns
counterclockwise and reinstall rod in hole in bracket.
 Check adjustment again by repeating step 5.
 When adjustment is correct, reinstall cotter pin in
rod.
  " 
"
The interlock switches in the electrical system
prevent the engine from starting unless the gear shift
is in neutral and the deck engagement lever is
disengaged. Also, the engine will stop Ċ because of
a seat switch Ċ if the operator gets off the seat when
the deck engagement lever is engaged or the gear
shift is in gear. To ensure the interlock system is
operating correctly, check it before each use of the
rider.
 Move the gear shift into neutral.
 Move the deck engagement lever into ENGAGE.
Sit on the seat and turn the ignition key to START.
The engine should not crank; if it does, the interlock
system is malfunctioning and it must be repaired by
an Authorized TORO Service Dealer. If the engine
does not crank, proceed to step 3.
 Move the deck engagement lever into
DISENGAGE. Sit on the seat, depress the brake and
clutch pedals, engage the parking brake and shift
into gear. Turn the ignition key to START. The engine
should not crank; if it does, the interlock system is
malfunctioning and must be repaired by an
Authorized TORO Service Dealer. If engine does not
crank, proceed to step 4.
 Sit on the seat, move the gear shift into neutral,
the deck engagement lever into DISENGAGE and
ensure the parking brake is engaged. Turn the
ignition key to START. The engine should start and
continue to run. Then engage the deck engagement
lever and carefully raise off the seat: the engine
should stop. If the engine does not stop running,
shut off the engine and have the interlock system
repaired by an Authorized TORO Service Dealer. If
the engine shuts off when you raised off the seat, the
interlock system is functioning correctly and the rider
can be operated safely.
0 /04 01'2#4' 4*' 2+&'2 +( 4*' +/4'2-0%,
3734'. +3 .#-(5/%4+0/+/) $'%#53' +4 +3 #
3#('47 &'6+%' &'3+)/'& 40 1204'%4 4*'
01'2#402
!