Installation Instructions

FormNo.3377-636RevB

24inNarrowDrumConversionKit

TR-34DTrenchRoller

ModelNo.68069

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Drum4

Narrowscraper8

Installthenarrowdrums.

InstallingtheNarrowDrums

RemovingtheWideScrapers

1.Settheparkingbrake;refertotheOwner’ sManual.

2.Removeboltsandwashersthatsecurethe8existing

scraperstothemachineandremovethescrapers.

Note:Retaintheboltsandwashersforinstallationof

thenarrowdrumscrapers.

Note:Retainthescrapersifyoudecidetoinstallthe

widedrumsontothemachine

Figure1

1.Washer3.Existingscraper

2.Bolt

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3377-636*B

PAGE 1
Form No. 3377-636 Rev B 24in Narrow Drum Conversion Kit TR-34D Trench Roller Model No. 68069 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Drum Narrow scraper 4 8 Install the narrow drums. Installing the Narrow Drums Removing the Wide Scrapers 1.
PAGE 2
Installing the Front Narrow Drums WARNING Mechanical or hydraulic jacks may fail to support machine and cause a serious injury. • Use jack stands when supporting machine. • Do not use hydraulic jacks. Important: Machine weight: 1406 Kg (3100 lb) Note: Remove and install one drum at a time, this allows the other drums to contact the ground for stability. 1. Lift the front of the machine high enough to slide a jack stand under the frame to support the machine (Figure 2). Figure 3 4. New narrow scrapers 5.
PAGE 3
Installing the Rear Narrow Drums 1. Lift the rear of the machine high enough to slide a jack stand under the frame to support the machine (Figure 5). g021598 2 1 Figure 5 1. Jack stand 2. Rear drum 2. Release the parking brake; refer to the Owner’s Manual. 3. Repeat steps 2 through 5 of Installing the Front Narrow Drums (page 2) for both rear drums. 4. Lower the rear of the machine. Installing the Narrow Scrapers 1.
PAGE 4